After 6.3 does the HDMI and Component outputs work at the same time?

[vid53]

Just wondering since the upgrade if both outputs work at the same time?

Vid53

[Runch Machine]

Just wondering since the upgrade if both outputs work at the same time?

Vid53

Yes, but only if you use the command to turn both on at the same time. You have to have hacked your Tivo and have Telnet access then enter:

si9190test -format 10801 -c 1 -d 1

[mst3k]

I have my component out going to my receiver then to component in1 on my panny 42 600U and it works. I have my HDMI out going to HDMI in2 on the same set. Both inputs work. Is that what you mean? I didn't have to enter any commands. Oddly tho if I have the component in and HDMI in on inputs 1, I don't get HDMI. I have to have component in input1 and HDMI into HDMI input 2 for it to work.

[A J Ricaud]

I have my component out going to my receiver then to component in1 on my panny 42 600U and it works. I have my HDMI out going to HDMI in2 on the same set. Both inputs work. Is that what you mean? I didn't have to enter any commands. Oddly tho if I have the component in and HDMI in on inputs 1, I don't get HDMI. I have to have component in input1 and HDMI into HDMI input 2 for it to work.

It' doubtful that both work at the same time. Some TVs shut off the input when it's not being used. In this case, if the HDMI from the rcvr. doesn't get a signal from the TV then component will work.