wild1
03-07-2006, 03:26 PM
I would appreciate help with getting MyDVD 6.2 to work!!!
Mydvd transcodes and writes the dvd without an error, but when I go to play the disk it fails (It pops and blurs on my dvd player and hangs in the same place when I play it on my computer in both Windows Media Player and Power DVD.)
Next I created an image with mydvd. The image played fine in DVD Shrink.
I then wrote the image to a disk using both Nero and MyDVD. There were playback errors each time, but in different locations.
Next I tried different media: Maxwell dvd+r, and Memorex Dvd +rw. This also resulted in errors in different places on playback.
I also tried this on multiple Tivo shows. Again each time there was a playback error - in a different place towards the middle or end of the movie.
I tried disabling the network, virus software etc during the write. This also did not work.
In the past I have created DVDs on this computer successfully, so I am hesitant to look around for new firmware, drivers, or aspi stuff.
My DVD writer is NEC DVD_RW ND-2510A. The Driver is Microsoft's generic version 5.1.2535.0 dated 7/1/2001. The driver file details as Provider: Roxio File version 7.1.0.188.
Any help would be appreciate!!!
Mydvd transcodes and writes the dvd without an error, but when I go to play the disk it fails (It pops and blurs on my dvd player and hangs in the same place when I play it on my computer in both Windows Media Player and Power DVD.)
Next I created an image with mydvd. The image played fine in DVD Shrink.
I then wrote the image to a disk using both Nero and MyDVD. There were playback errors each time, but in different locations.
Next I tried different media: Maxwell dvd+r, and Memorex Dvd +rw. This also resulted in errors in different places on playback.
I also tried this on multiple Tivo shows. Again each time there was a playback error - in a different place towards the middle or end of the movie.
I tried disabling the network, virus software etc during the write. This also did not work.
In the past I have created DVDs on this computer successfully, so I am hesitant to look around for new firmware, drivers, or aspi stuff.
My DVD writer is NEC DVD_RW ND-2510A. The Driver is Microsoft's generic version 5.1.2535.0 dated 7/1/2001. The driver file details as Provider: Roxio File version 7.1.0.188.
Any help would be appreciate!!!