View Full Version : HD/Off Air/HR10-250 Connections
01-17-2006, 04:05 PM
OK, I have the HR10-250 w/ a 3LNB dish. I bought an OTA antenna and have it set up correctly when it is connected directly to the HR10-250, but I was told when purchasing the antenna, that I could connect it directly to the multi switch and then use a diplexer at the box. Two problems, one is when I connect it the way I was told, the box did not pick up the signal and two, I have a four input multi switch and they are all being used up by the directv/tivo lines from the dish. I would hate to buy a new multi switch if connecting the OTA antenna through it doesn't work anyway. Any ideas, suggestions or places I can go to get more info? Thanks.
01-17-2006, 04:39 PM
Two problems, one is when I connect it the way I was told, the box did not pick up the signal and two, I have a four input multi switch and they are all being used up by the directv/tivo lines from the dish.
These two problems, as you might imagine :), are related. What the dealer told you is true of a five-input multiswitch, where the fifth input is for OTA, and which contains a built-in diplexer to diplex the OTA onto the output lines. With your 4xn multiswitch you could use a single diplexer to diplex the OTA onto one of the output lines of your multiswitch, or a combination of diplexers and splitters to diplex the OTA onto all of the output lines. Or, you could replace your 4xn multiswitch with a 5xn multiswitch instead.
01-17-2006, 07:11 PM
thanks..I went ahead and used the diplexer on the output to my HR10-250. BUt I lost ABC which here in Dallas is on a low frequency (9). Could that be due to the two diplexers and that there is a lot of wiring connecting all the parts? Because the satellite has not moved and I received the channel clearly when the antenna was connected directly to the box
01-17-2006, 07:43 PM
You have discovered the problem with diplexing. Any time you use a diplexer you lose a little bit of the signal. Your ABC signal was probably somewhat marginal and the diplexer lowered it enough so that the HDTiVo can no longer lock on. You need to add an amplifier to the OTA. But, then you may lose other channels as the HDTiVo can be overloaded with too much signal. So get an amp that can be varied.
vBulletin® v3.6.8, Copyright ©2000-2013, Jelsoft Enterprises Ltd.