Need a Little Advice for Setup through receiver/dvd player

[Frank784]

I've recently acquired my first Tivo, and I'm trying to set it up in conjunction with my xbox360, ps2, and my Low/end Receiver/DvD player. I have no cable boxes, so just straight from the wall, split to the Television/Tivo. My receiver has 2 A/V inputs, an A/V output, and a R/G/B/S Video output. My Television is a little old, and only has 1 set of A/V in, along with the RF in. If anyone has any reccomendations in which way I can set this up for optimum usage for everything.

Thanks,
Frank

[dirtypacman]

You should get a device switch --- will allow one set of wires from switch to TV and multipule connections to switch from all of your devices.

You can get em for cheap at most electronics stores.

Either that or you will be doing a whole lot of pass throughs to get your signal to TV.

[Frank784]

I was trying to see if there was some better way, because as it is before I got my Tivo, the Receiver/Dvd player is setup as a switch itself. through that, I switch between its DVD player part, the Xbox plugged into it, along with the ps2. And since everything is plugged directly into the Receiver/DVD player, I just have the A/V outputs from it plugged into the back of my television, and everything was perfect, until I got the Tivo and it seems to have complicated my setup.

[JimSpence]

Unless you get another TV with more inputs, or a new A/V receiver with more AV switching capability, then the switch mentioned by dirtypacmsan is what you need.

Any on this page will work just fine.
http://www.radioshack.com/search/index.jsp?kwCatId=&kw=av%20switch

[Frank784]

Well thank you both very much. I was afraid the prices would be quite a bit more steep.