1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tivo changes channel when uning system on

Discussion in 'TiVo Help Center' started by caddyroger, Dec 31, 2012.

  1. caddyroger

    caddyroger New Member

    Mar 14, 2005
    Some where...
    J have tivo elite. I use a Harmony one remote to turn on a Toshiba dlp tv and a Yamaha receiver. When I power up the system the tivo changes to a blank channel. What could be the cause of this?
  2. Doit2it

    Doit2it Member

    Jan 3, 2006
    Nashville, TN
    Have you been using the HOne for a while and this just started, or are you new to the HOne used with Tivo?

    Sounds like the way input is setup in the Harmony One software. Try deleting the activity and setting it up again. If that doesn't work, delete the the Tivo device and set it up again then the Activity. Tivo should always be "This device doesn't have a power button"
  3. steve614

    steve614 what ru lookin at?

    May 1, 2006
    Dallas, TX
    Are you sure the Tivo is not going into stand-by?
    Unless you tell it specifically not to, the harmony software will put the Tivo in stand-by when you shut down, and the Tivo may be out of sync with the rest of the equipment.

    Is there a 'Help' button on the Harmony One? If so, press it the next time this happens and see if the Tivo comes up.

Share This Page