1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help with HD install in Directv TRH22

Discussion in 'DirecTV TiVo Powered PVRs & Receivers' started by bthrelkeld777, Aug 1, 2012.

  1. bthrelkeld777

    bthrelkeld777 New Member

    1
    0
    Jul 30, 2012
    Hello everyone,
    I have a question regarding upgrading the hard drive on the DirecTV TiVo THR22. When I removed the black bracket that holds the hard drive I foolishly did not notice where the black wire was going. You know the wire the kind of wraps around it. I know it goes back in the little ridges along the sides of the black bracket but the ridges end at the separator panel piece and after that I'm not sure where it went. It drove me nuts I couldn't find where that little brass socket thingy at the end was supposed to go. So I routed the wire underneath the separator panel to the other side and sort of wrapped it around one of the posts holding the fan wire and left the little brass thing just sort of in the air. I'm guessing it has something to do with measuring the temperature. The new 2TB WD AV-GP (WD20EURS) HD I put in has worked flawlessly. Absolutely nothing wrong, it shows 42°C in the system information, pretty normal.

    So the question really is where should that brass thingy have ended up? Opening it back up is no big deal for me, but at the moment there doesn't seem to be any reason to unless someone here to give me information otherwise.

    Thank you so much.
     
  2. stevel

    stevel Dumb Blond TCF Club

    28,197
    29
    Aug 23, 2000
    Nashua, NH
    That wire is for the RF remote antenna. If you're not using the RF feature of the remote, you can ignore it. The corresponding socket is approximately in the center of the motherboard.
     

Share This Page